Medisafe Sonic Irrigator “SA” - tabletop cannulated instrument-cleaning system, for cleaning cannulated instruments both inside and out, in a fully validated, clinically tested process. 

Our system features: automatic fill / auto enzyme injection / auto sonic-flush wash / auto sonic-flush rinse / auto drain capabilities!  Cleaning up to 12 instruments both inside and outside of the instruments, in a tested & proven process of approximately 25 minutes!  

The SI-SA also provides the operator an optional “quick turnaround mode” by retaining the prior wash water for immediate reuse in cleaning the next instrument load.
 
Special plumbing/drainage required and is responsibility of purchaser (call for installation specifications) standard 110v electrical required Optional cabinet available  (#MET110) to convert tabletop to convenient floor model.

6.6 gal tank size
28.1” length x 17.5” width x 12.5” high (add 15” with lid open).
For optimal cleaning performance use recommend
      3E-Zyme Triple Enzyme Cleaning Solution  (#MEDIS-12041)

Specifications
Sonic Irrigator – Semi Auto (SA)   #MED1116USA

Quality

Manufactured in the UK under Medisafe’s IS09001 Quality

Use

For internal and external cleaning of cannulated / lumened surgical instrumentation

Environmental

For indoor use at altitudes up to 2000m / 6000ft
Operating temperature -5°C / 23°F   to   40°C / 104°F
Humidity -80% RH max for temperatures up to 31°C / 88°F,
decreasing linearly to 50% RH at 40°C / 104°F
Designed for Pollution Degree 2, i.e. not totally sealed.

Electricity Supply

110v AC 50 / 60Hz
Power Consumption: 0.8KVA max.
Termination: 3 pin type earthed plug (fused @ 13A if UK)
Lead Length: 1.83M (6 feet)

General Description

Medical Device Class I

Capacity

23 L / 6.1 G  Approx per stage
12 Cannulated Instruments (Max)
2 Kilos / 4.4 lb of instruments

Required Utilities

Water Supply

Cold water supply terminating into a Male ¾” NPT National Pipe Thread for (plastic) hose  fitting

Hot water supply terminating into a Male ¾” NPT National Pipe Thread  for (plastic) hose fitting.  

Optimum pressure: 1.5 BAR (22 psi)

Acceptable Pressure Range: 1.5 – 2.5 BAR (21 – 35 psi) hot & cold

Acceptable Temp. Range: Hot:  55°C /  141°F   - 75°C / 167°F
Cold  5°C  / 41°F– 25°C / 77°F   

Hardness CaCo3: not more than 115 ppm (HTM2030)

Drain

Discharge Orifice Type: 18mm outside dia. unthreaded hose tail.

Drain position: Main Drain entry should be below level of discharge orifice with no part of the drain hose above the orifice (i.e. no loops in the hose) Standard washing / dishwasher drain with trap.

Weir Overflow: An elbow adapter to 32mm push fit waste pipe, this is routed to a suitable 40mm waste trap behind machine. Two traps required in total.  This is in case of fault. Under normal operating conditions only water vapor will exit.

Weight

Operational weight/ wet: 51 kgs / 112.4lbs
Shipping weight/dry: 30 kgs / 66.1lbs
Dimensions:  Chamber volume: 25,000 cm3
Outer Dimensions: 28.1”(w)  x   17.5”(d)  x  13.2”(h)